Get better, brighter workshop lighting by switching from fluorescent bulbs to LEDs.
Turns on instantly, no flickering, ability to create focused light and omni-directional light.
Check the label info on your current bulbs to find their color temperature.If you get a continuity reading, the sockets are shunted and must be replaced with non-shunted units.However, there are still some instances where an HID is still a smart choice.Before You Buy, decide whether you want a clear or diffused lens.Most older fluorescent fixtures xhover win 2 micro have boehringer ingelheim discount card shunted sockets, which means the internal contacts are connected with a copper shunt strap.LEDs will last much longer, but light output will continue to decrease over time.The advantage: Youll never have to replace any ballasts.The prices below assume 48-in.The advantage of this option is that youll never have to worry about replacing ballasts.Lumileds cannot accept any responsibility and/or liability.Reinstall the end cap and reflector/cover.If you dont have18-gauge wire on hand, you can repurpose the existing wires from your old ballast.They cost about 15 each.Buy entirely new replacement, lED fixtures.Which, lED lamp do you need?Choose a clear lens if the fixture gifts for jeep lovers is directly over your work area and a diffused lens for lighting large areas.Never try to modify a socket to fit your fixture!Bulbs and two-bulb fixtures.Turn off the power to the fixture and disconnect the wires going to each socket.
Probe across the copper contacts in each socket.